Sony Car Stereo System D E525 User Manual

To u se t h e re m o t e co n t ro l  
The lever marked with =-^-+ is the  
jog lever. When you press or slide the lever,  
operation starts.  
zOt h e r Op e ra t io n s  
3-867-190-21 (1)  
Pla yin g t ra cks in ra n d o m  
o rd e r (Sh u ffle Pla y)  
Usin g o t h e r fu n ct io n s  
Pla yin g t ra cks re p e a t e d ly  
(Re p e a t Pla y)  
To m in im ize skip p in g (ESP2)  
Playing a CD right  
away!  
The ESP (Electronic Shock Protection)  
function minimize skipping by using a buffer  
memory that stores music data and plays it  
back in the event of a shock.  
You can play the tracks in a CD in random  
order.  
You can play tracks repeatedly in normal,  
INTRO PGM, shuffle or RMS (Random Music  
Sensor) play modes. Repeat all the tracks or  
only one track.  
The new ESP2 (ESP Squared) system uses a  
new DSP (Digital Signal Processor) which can  
read and store music data more efficiently,  
providing a level of continuous skip  
protection not found in traditional buffer  
memory units. This decreases the frequency  
of sound skipping and the need to utilize the  
buffer memory. Use this function when  
listening in a car or while walking.*  
Slide  
Slide  
^
If you want to play a CD right now, choose to use your player on house  
current. Other choices are the following three: rechargeable batteries,  
dry batteries (see “Power Sources” on the reverse side) and car battery.  
Press  
+
=
Co m p a ct Disc  
Co m p a ct Pla ye r  
P MODE  
To  
Do this  
During play, press P MODE repeatedly until  
“SHUF” appears.  
The tracks play in random order.  
Pause  
Press the jog lever  
* Although ESP2 provides excellent protection  
against skipping, it will not prevent skipping  
while jogging or running.  
toward ^.  
Resume play after  
pause  
Press the jog lever  
toward ^.  
1
P MODE RPT/ENT  
Connect  
Operating Instructions  
To re p e a t a ll t h e t ra cks  
Press RPT/ ENT (REPEAT/ ENTER on the  
player) during play.  
Find the beginning  
of the current track  
(AMS*)  
Slide the jog lever  
toward =  
once.**  
to a wall  
Ab o u t a re a co d e  
outlet  
The area code of the player you purchased is shown on upper left of the bar  
code label on the package.  
For accessories supplied with your player, check the area code of your model  
and refer to “Supplied accessories” toward the end of this manual.  
The “  
” indication appears.  
To cancel shuffle play, press P MODE  
repeatedly until the play mode indication  
disappears from the display.  
When using  
earphones  
Find the beginning  
of previous tracks  
(AMS)  
Slide the jog lever  
ESP  
toward  
=
Press ESP.  
The ESP indication appears.  
repeatedly.**  
Note  
• During shuffle play, you cannot return to  
previous tracks by sliding the jog lever toward  
= .  
Find the beginning  
of the next track  
(AMS)  
Slide the jog lever  
toward +  
once.**  
AC power adaptor  
To cancel repeat play, press RPT/ ENT again.  
To re p e a t a sin g le t ra ck  
1 Press RPT/ ENT while the track you want  
to repeat is playing.  
Find the beginning  
of succeeding  
tracks (AMS)  
Slide the jog lever  
toward  
repeatedly.**  
+
Pla yin g t ra cks in t h e o rd e r  
yo u w a n t (RMS p la y)  
To release the ESP function, press ESP again.  
Earphones  
The “  
” indication appears.  
Notes  
Slide and hold the  
jog lever toward  
+.**  
Go forward  
quickly  
• Playing may stop when the player gets a strong  
shock even with the ESP function on.  
• You may hear a noise or sound skip when:  
— listening to a dirty or scratched CD,  
— listening to an audio test CD or,  
— the player receives continuous shock.  
• Sound may drop for a while if you press ESP  
during play.  
You can program up to 22 tracks to play in  
any order you choose.  
^
Slide and hold the  
jog lever toward  
=.**  
Go backwards  
quickly  
2 Press P (play) MODE (PLAY MODE on the  
player) repeatedly until “1” appears.  
+
=
p
DC IN 4.5 V  
*AMS = Automatic Music Sensor  
**These operations are possible during both  
play and pause.  
• When you use an optical digital connecting  
cord, the ESP function will be disabled.  
2/REMOTE  
D-E525  
Sony Corporation ©1999 Printed in Malaysia  
To e n jo y m o re p o w e rfu l b a ss so u n d  
(So u n d fu n ct io n )  
You can enjoy a powerful bass-boosted sound.  
If you press RPT/ ENT (REPEAT/ ENTER on  
To repeat another track, slide the jog lever  
toward = or + .  
For models supplied w ith the AC plug adaptor  
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.  
P MODE  
RPT/ENT  
the player) to display “  
”, you can locate the  
tracks continuously in the following order:  
• When using +: next track n next track  
...... last track n first track n second track  
......  
• When using =: previous track n previous  
track ...... first track n last track ......  
1
2
During play, press P MODE repeatedly  
until “RMS*flashes.  
To cancel repeat play, press RPT/ ENT again.  
For models supplied w ith the remote control  
• Connect the plug of the earphones to the remote control.  
• Connect the earphones to the remote control firmly. A loose connection may cause noise  
during playback.  
Flashing  
Fo r t h e cu st o m e rs in t h e USA  
We lco m e !  
This equipment has been tested and found to  
comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules.  
Pla yin g o n ly t h e t ra cks  
yo u w a n t (INTRO PGM Pla y)  
You can do the operations shown in the above  
table using the buttons with the same marks  
on the player.  
SOUND  
Thank you for purchasing the Sony  
Compact Disc Compact Player.  
Before operating your player, please  
read this manual and retain it for  
future reference.  
These limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation. This equipment  
generates, uses, and can radiate radio frequency  
energy and, if not installed and used in  
accordance with the instructions, may cause  
harmful interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipment does cause harmful interference to  
radio or television reception, which can be  
determined by turning the equipment off and on,  
the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment  
and receiver.  
- Connect the equipment into an outlet on a  
circuit different from that to which the receiver  
is connected.  
- Consult the dealer or an experienced radio/ TV  
technician for help.  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate this  
equipment.  
Press SOUND to select “MB (Mega Bass)” or  
“GRV (Groove).” “GRV” is more effective.  
2
*RMS = Random Music Sensor  
You can choose and play your favorite tracks  
by scanning through the beginning of each  
Place a CD  
To re m o ve t h e CD  
Remove the CD while  
pressing the pivot.  
Slide the jog lever toward = or + to  
choose a track.  
The track number and the playing order  
appear.  
Note  
track in a CD.  
^
• If the sound is distorted when emphasizing  
bass, turn down the volume.  
+
=
Ow n e r’s Re co rd  
p
The model and the serial numbers are located at  
the bottom. Record the serial number in the  
space provided below. Refer to these whenever  
you call upon your Sony dealer regarding this  
product.  
To lo ck t h e b u t t o n s  
You can lock your player against any  
accidental operations.  
You can still operate the player with the  
remote control.  
Track number  
Flashing  
Notes on controlling the volume w ith the  
remote control  
Set the VOL (volume) control on the remote  
control to the maximum. Then adjust the  
volume on the player to the level that you  
want to be the maximum volume of the remote  
control.  
D-E525  
Serial No.________________________  
RPT/ENT  
P MODE  
Playing order  
1
During play, press P MODE repeatedly  
until “INTRO PGM” flashes.  
WARNING  
3
4
Press RPT/ ENT to program the track.  
Flashing  
To p re ve n t fire o r sh o ck  
h a za rd , d o n o t e xp o se  
t h e u n it t o ra in o r  
m o ist u re .  
Repeat steps 2 and 3 to program the  
remaining tracks.  
Label side up  
OPEN  
Notes on display  
• When you press ^ (when RESUME is set to  
OFF), the total number of tracks in the CD  
and the total playing time appear for about 2  
seconds.  
• During play, the track number and the  
elapsed playing time of the current track  
appear.  
• During pause, the elapsed playing time  
flashes in the display.  
• Between tracks, the time to the beginning of  
the next track will appear with the “–”  
indication.  
1Slide OPEN to open the lid.  
2Fit the CD to the pivot.  
5
Press the jog lever toward ^ .  
“RMS” stops flashing and the tracks you  
have chosen play in the order you  
specified.  
3Close the lid.  
2
3
Press the jog lever toward ^ to start  
scanning.  
The player plays about the first 15  
seconds of each track and “INTRO PGM”  
flashes faster.  
To a vo id e le ct rica l  
sh o ck, d o n o t o p e n t h e  
ca b in e t . Re fe r se rvicin g  
t o q u a lifie d p e rso n n e l  
o n ly.  
Slide HOLD in the direction of the arrow.  
When you press any button, “Hold” appears in  
the display and you cannot operate the player.  
If you press p, the program will be erased. To  
prevent accidental erasure, set the RESUME  
switch at the rear of the player to ON.  
Fo r t h e cu st o m e rs in Au st ra lia  
The supply cord of the AC power adaptor cannot  
be replaced; if the cord is damaged, the AC  
power adaptor should be discarded.  
3
Play  
Press RPT/ ENT while the track you want  
is playing. To skip the track, slide the jog  
lever toward + or just wait for the next  
track.  
To unlock, slide HOLD back.  
To cancel RMS play, press P MODE until  
“RMS” disappears from the display.  
2 Adjust the volume.  
Fo r t h e cu st o m e rs n o t in Eu ro p e  
The CE mark on the unit is valid  
only for products marketed in the  
European Union.  
To u se t h e p la ye r  
Notes on handling CDs  
• To keep the CD clean, handle it by its edge.  
Do not touch the surface.  
• Do not stick paper or tape onto the CD.  
• Do not expose the CD to direct sunlight or  
heat sources such as hot air ducts. Do not  
leave the CD in a car parked under direct  
sunlight.  
CAUTION  
To ch e ck t h e p ro g ra m  
During programming:  
Press RPT/ ENT before step 5.  
During RMS play:  
Press P MODE repeatedly until “RMS”  
flashes, then press RPT/ ENT.  
Each time you press RPT/ ENT, the track  
number and the playing order appear in the  
order you specified.  
The use of optical instruments with this product  
will increase eye hazard.  
After you have gone through the CD,  
“INTRO PGM” stops flashing and the tracks  
you have chosen play automatically.  
Continue to the reverse side m  
1 Press ^.  
To finish programming before going through  
the whole CD, press the jog lever toward ^.  
The selected tracks will be played.  
1 Press the jog  
lever toward  
^.  
If you press p, the program will be erased.  
To prevent accidental erasure, set the  
RESUME switch at the rear of the player to  
ON.  
2 Adjust the volume.  
Note  
• If you program another track after the 22nd  
track, the first track programed is cleared and  
the new track is programed instead.  
Not these ways  
To cancel INTRO PGM play, press P MODE  
repeatedly until the play mode indication  
disappears from the display.  
To stop play, press p.  
 

Shark Vacuum Cleaner NV100 User Manual
Sharp CRT Television LC 40LE510E User Manual
Snapper Snow Blower 3190E User Manual
Sony Blu ray Player BDP S480 User Manual
Sony CD Player CDX 6500 User Manual
Sony Speaker SRS A205 User Manual
SOYO Personal Computer SY 6BA+ IV User Manual
Stanton CD Player S25O User Manual
Sunbeam Humidifier 1361 705 User Manual
Sylvania MP3 Player SMPK20722GB User Manual