Sony Radio ICFCDK50 User Manual

CAUTION  
WARNING  
To reduce the risk of fire or electric shock, do not  
expose this apparatus to rain or moisture.  
Troubleshooting  
3-287-075-11 (1)  
You are cautioned that any changes or modifications  
not expressly approved in this manual could void your  
authority to operate this equipment.  
AC power cord  
Cord clamp  
Should the problem persists after you have made the  
following checks, consult your nearest Sony dealer.  
To reduce the risk of electrical shock, do not  
open the cabinet. Refer servicing to qualified  
personnel only.  
The clock does not show the correct time.  
For customers in the USA  
Has an electrical power outage occurred?  
Please register this product on line at  
The CD player does not operate.  
Did you close the disc tray?  
Did you place the disc correctly?  
The disc should be placed with the labeled side up.  
Dusty or defective disc—Clean the disc with an  
optional cleaning cloth. Wipe the disc from the  
center out.  
Take out the CD and leave the CD compartment  
open for about an hour to allow condensation to  
evaporate.  
To reduce the risk of fire, do not cover the ventilation  
of the apparatus with newspapers, tablecloths,  
curtains, etc. And do not place lighted candles on the  
apparatus.  
Proper registration will enable us to send you  
periodic mailings about new product, services and  
other important announcements. Registering your  
product will also allow us to contact you in the  
unlikely event that the product needs adjustment  
or modification. Thank you.  
FM/AM CD Kitchen  
The apparatus shall not be exposed to dripping or  
splashing and no objects filled with liquids, such as  
vases, shall be placed on the apparatus.  
Clock Radio  
As the main plug is used to disconnect the unit from  
the mains, connect the unit to an easily accessible AC  
outlet.  
Should you notice an abnormality in the unit,  
disconnect the main plug from the AC outlet  
immediately.  
Important Safety Instructions  
1) Read these instructions.  
2) Keep these instructions.  
3) Heed all warnings.  
4) Follow all instructions.  
Operating Instructions  
Sporadic loss of sound during CD operation.  
Dusty or defective disc—Clean or replace the disc.  
Excessively high volume—Reduce the volume.  
Strong vibration.  
5) Do not use this apparatus near water.  
6) Clean only with dry cloth.  
7) Do not block any ventilation openings.  
Install in accordance with the manufacturers  
instructions.  
8) Do not install near any heat sources such  
as radiators, heat registers, stoves, or other  
apparatus (including amplifiers) that produce  
heat.  
9) Do not defeat the safety purpose of the polarized  
or grounding-type plug. A polarized plug has  
two blades with one wider than the other. A  
grounding type plug has two blades and a  
third grounding prong. The wide blade or the  
third prong are provided for your safety. If the  
provided plug does not fit into your outlet,  
consult an electrician for replacement of the  
obsolete outlet.  
Do not install the appliance in a confined space, such  
as a bookcase or built-in cabinet.  
There is a noise from the speakers.  
You may hear a noise when you operate the remote  
during an AM broadcast.  
Notes on DualDiscs  
A DualDisc is a two sided disc product which mates  
DVD recorded material on one side with digital  
audio material on the other side. However, since the  
audio material side does not conform to the Compact  
Disc (CD) standard, playback on this product is not  
guaranteed.  
The remote does not work.  
Remove any obstacles between the remote and the  
remote sensor on the unit, and move the unit away  
from fluorescent lights.  
Point the remote at the system’s sensor.  
Move the remote closer to the system.  
Spacer  
Owner’s Record  
The model number and the serial number are located on the top.  
Record the serial number in the space provided below. Refer to them whenever you call upon  
your Sony dealer regarding this product.  
Music discs encoded with  
copyright protection technologies  
L (Low)  
This product is designed to playback discs that  
conform to the Compact Disc (CD) standard.  
Recently, various music discs encoded with copyright  
protection technologies are marketed by some  
record companies. Please be aware that among those  
discs, there are some that do not conform to the CD  
standard and may not be playable by this product.  
Specifications  
Model No. ICF-CDK50  
Serial No.  
Template  
Dot  
AUDIO POWER SPECIFICATIONS  
10) Protect the power cord from being walked on  
or pinched particularly at plugs, convenience  
receptacles, and the point where they exit from  
the apparatus.  
POWER OUTPUT AND TOTAL HARMONIC  
DISTORTION  
With 4-ohm loads, both channels driven from  
100 – 10 000 Hz; rated 1.5 W per channel-minimum  
RMS power, with no more than 10% total harmonic  
distortion in AC operation.  
For customers who purchased this product in the USA  
Please register this product on line at  
Proper registration will enable us to send you periodic mailings about new products,  
services, and other important announcements. Registering your product will also  
allow us to contact you in the unlikely event that the product needs adjustment or  
modification. Thank you.  
CAUTION  
11) Only use attachments/accessories specified by the  
The use of optical instruments with this product will  
increase eye hazard.  
manufacturer.  
12) Use only with the cart, stand, tripod, bracket, or  
table specified by the manufacturer, or sold with  
the apparatus. When a cart is used, use caution  
when moving the cart/apparatus combination to  
avoid injury from tip-over.  
Use of controls or adjustments or performance of  
procedures other than those specified herein may  
result in hazardous radiation exposure.  
To reduce the risk of fire, do not place any heating or  
cooking apparatus beneath this unit.  
CD player section  
System: Compact disc digital audio system  
Laser diode properties:  
Emission duration: Continuous  
Laser output: Less than 44.6 µW  
(This output is the value measured at a distance of  
about 200 mm from the objective lens surface on  
the optical pick-up block with 7 mm aperture.)  
ICF-CDK50  
© 2007 Sony Corporation  
Number of channels: 2  
+1  
Frequency response: 20 – 20 000 Hz  
dB  
13) Unplug this apparatus during lightning storms or  
when unused for long periods of time.  
–2  
Printed in China  
Wow and flutter: Below measurable limit  
Mounting screw  
14) Refer all servicing to qualified service personnel.  
Servicing is required when the apparatus has  
been damaged in any way, such as power-supply  
cord or plug is damaged, liquid has been spilled  
or objects have fallen into the apparatus, the  
apparatus has been exposed to rain or moisture,  
does not operate normally, or has been dropped.  
Radio section  
Frequency range:  
FM: 87.5 – 108 MHz  
AM: 530 – 1 710 kHz  
Antennas:  
FM: AC power cord  
AM: Built-in ferrite bar antenna  
This symbol is intended to alert the user  
to the presence of uninsulated “dangerous  
voltage” within the product’s enclosure that  
may be of sufficient magnitude to constitute  
a risk of electric shock to persons.  
General  
Precautions  
“Specifications” to operate the unit.  
The nameplate indicating operating voltage, power  
consumption, etc. is located on the top exterior.  
Time display: 12-hour system  
Speaker: 66 mm (2 58 inches) diam., 4 Ω, cone type (2)  
Input:  
Built-in audio cable with stereo miniplug (1):  
minimum input level 245 mV, impedance 47 kΩ  
Power outputs:  
Use the power source specified in the  
This symbol is intended to alert the user to  
the presence of important operating and  
maintenance (servicing) instructions in the  
literature accompanying the appliance.  
To disconnect the power cord (mains lead), pull it  
out by the plug, not the cord.  
1.9 W + 1.9 W (at 4 Ω, 10 % harmonic distortion)  
Power requirements: 120 V AC, 60 Hz  
For Power backup: 3 V DC, one CR2032 battery  
Dimensions:  
The graphical symbols are at the top of the enclosure.  
1 Decide on the installation location and  
orientation of the unit based on the best  
reception that is possible (see “Improving  
the reception”).  
Do not leave the unit in a location near a heat source  
such as a radiator or air duct, or in a place subject to  
direct sunlight, excessive dust, mechanical vibration,  
or shock.  
Allow adequate air circulation to prevent internal  
heat build-up. Do not place the unit on a surface  
(a rug, a blanket, etc.) or near material that might  
block the ventilation holes such as a curtain.  
Should any solid object or liquid fall into the unit,  
unplug the unit and have it checked by a qualified  
personnel before operating it any further.  
To clean the casing, use a soft cloth dampened with  
a mild detergent solution.  
Installing the unit under a  
cabinet  
Class II equipment symbol  
This symbol indicates that the unit has a  
double insulation system.  
Approx. 350 85 300 mm (w/h/d)  
(Approx. 13 78 3 38 11 7  
8 inches)  
incl. projecting parts and controls  
(See Fig. )  
2 Mark the position of the 4 holes by using  
the supplied template. Use a drill to make  
the holes (size 6.5 mm diam., 9/32 inch). (See  
Fig. -)  
Mass: Approx. 2.7 kg (6 lb 1 oz)  
INFORMATION  
Supplied accessories:  
mounting screws (M5 screw) (4)  
template (1)  
Caution  
This equipment has been tested and found to  
comply with the limits for a Class B digital device,  
pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection against  
harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications. However, there  
is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause  
harmful interference to radio or television reception,  
which can be determined by turning the equipment  
off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment  
and receiver.  
Please read the following before  
installing the unit  
spacers (4)  
cord clamp (1)  
remote commander (1)  
digital music player holder (1)  
3 When the cabinet door overhangs the shelf  
and obstructs the unit, you can adjust the  
unit/shelf height.  
Due to its heavy weight, the unit should be installed  
with great care.  
The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the wall  
outlet, even if the unit itself has been turned off.  
Installation of the unit requires two persons.  
Use tools carefully while installing of the unit.  
Be sure that the cabinet that is used is sturdy enough  
to support the weight of the unit.  
To reduce the risk of fire, do not place any heating or  
cooking appliance beneath this unit.  
Install the unit so that its AC power cord can be  
connected directly to a wall outlet. Do not use a  
converter or extension cord.  
Be sure that the AC power cord has no slack during  
use of the unit, since the cord acts as an FM wire  
antenna. If the AC power cord has some slack, wind  
it around the cord hook so as to eliminate the slack.  
First set the L mark to the dot which  
becomes the lowest position, then you  
can adjust the height in 4 steps (HL)  
by turning the spacer counterclockwise  
(See Fig. -). The unit can be installed  
without the spacer.  
Design and specifications are subject to change  
without notice.  
If you have any questions or problems  
concerning your unit, please consult your nearest  
Sony dealer.  
4 Install the unit with the supplied mounting  
screws. (See Fig. -)  
Note  
If you lose the supplied screws, please purchase #10 or  
Connect the equipment into an outlet on a  
circuit different from that to which the receiver  
is connected.  
Consult the dealer or an experienced radio/TV  
technician for help.  
M5 screws.  
The unit has a built-in ferrite bar antenna for AM  
radio reception. Confirm that AM reception is  
acceptable before finally attaching the unit.  
Install the unit as far as possible from sources of  
noise (for example, a refrigerator, microwave oven or  
fluorescent lamp).  
This unit is not waterproof. Install it where it will  
not be exposed to splashing by water, as this may  
damage the unit.  
WARNING  
Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or equivalent  
type.  
Replace the battery for the clock backup with a Sony  
CR2032 lithium battery. Use of another battery may  
present a risk of fire or explosion.  
To reduce the risk of fire or electric shock, do not  
touch the AC power cord with wet hands.  
Never place objects between the top of the unit and  
the bottom of the cabinet. This could cause the unit  
to fall.  
Make sure the unit’s four screws are fastened tightly.  
After installing the unit, do not pull down on it or  
hang something heavy on it.  
Battery may explode if mistreated. Do not recharge,  
disassemble or dispose of in fire.  
Do not expose the batteries (battery pack or batteries  
installed) to excessive heat such as sunshine, fire or  
the like for a long time.  
Dispose of used battery promptly. Keep away from  
children.  
 

Shure Microphone SM93 User Manual
Smooth Fitness Treadmill 425 User Manual
Soleus Air Fan FT1 25 20 21 User Manual
Sony Computer Monitor CPD 20SF2T5 User Manual
Sony Speaker SWF BR100 User Manual
Speed Queen Clothes Dryer 40125301 User Manual
Sunfire Stereo Amplifier 913 047 00 User Manual
Sun Microsystems Stereo Amplifier IN3264 User Manual
Symphonic DVD Recorder SR90VE User Manual
TANDBERG Digital Camera D1404102 User Manual