StarTechcom Cable Box ST121UTPDVEU User Manual

Instruction Manual  
DVI Video Extender over CAT5 UTP  
ST121UTPDVI / ST121UTPDVGB / ST121UTPDVEU  
DE: Bedienungsanleitung - de.startech.com  
FR: Guide de l'utilisateur - fr.startech.com  
ES: Guía del usuario - es.startech.com  
IT: Guida per l'uso - it.startech.com  
Local Unit  
NL: Gebruiksaanwijzing - nl.startech.com  
PT: Guia do usuário - pt.startech.com  
Packaging Contents  
• 1 x DVI Extender Local Unit  
• 1 x DVI Extender Remote Unit  
• 2 x Power Adapter  
Remote Unit  
• 1 x Instruction Manual  
System Requirements  
• DVI enabled video source device (i.e. computer, PVR/DVR, etc)  
• DVI enabled video display device (i.e. monitor, projector, etc)  
• Available AC electrical out at local/remote locations  
Preparing Your Site  
1.Determine where the local video source (i.e. computer) will be  
located and set up the device.  
Installation  
1.Turn off the video source (i.e. computer) and the intended display  
device (i.e. monitor).  
2.Determine where the remote display will be located and place/  
mount the display appropriately.  
3.If you are using surface cabling, ensure you have enough Cat5  
unshielded twisted pair (UTP) Ethernet cabling to connect the  
Local Unit to the Remote Unit’s location, and that each end is  
2.Position the Remote Unit near the intended display.  
3.Position the Local Unit near the video source.  
Please note that both units will require a power connection, so  
please ensure that each unit is situated near an available power  
outlet.  
terminated with a RJ45 Ethernet connector. The cabling should not 4.Connect the video source to theDVI Inport on the rear panel of  
go through any networking equipment (i.e. router, switch).  
OR  
the Local Unit, using a DVI-D male/male cable.  
5.Connect the intended display to theDVI Outport located on the  
rear panel of the Remote Unit using a DVI-D male/male cable.  
6.Connect the Local Unit to the Remote Unit, using standard RJ45  
terminated CAT5 cable (see Preparing Your Site).  
7.Connect the power adapters (provided) to both Local and Remote  
Units.  
If you are using premise cabling, ensure that the Cat5 unshielded  
twisted pair (UTP) Ethernet Cabling between the Local Unit and  
the Remote Unit has been properly terminated in a wall outlet in  
each location and there is a patch cable long enough to connect  
the Remote Unit and the Local Unit to their respective outlets. The  
cabling should not go through any networking equipment (i.e.  
router, switch).  
8.Turn on the display device first, followed by the video source.  
Manual Revision: 02/07/2012  
 

Sharp Projector XV Z3100 User Manual
Silex technology Network Router SX 2000WG User Manual
Silvercrest Food Saver SFS 150 A2 User Manual
Sony Automobile Electronics CCD TR514 User Manual
Sony Computer Monitor MFM HT95 User Manual
Sony CRT Television 111 User Manual
Sony Personal Computer VPCX11 User Manual
Sony Projector VPL HS2 User Manual
Speco Technologies Security Camera CVC 340LC W User Manual
Starmax Resource Telescope 127 User Manual