Sunbeam Styling Iron HS7900 User Manual

Salon Finish  
Mini Professional Straightener  
INSTRUCTION BOOKLET.  
PLEASE READ THIS BOOK THOROUGHLY AND RETAIN FOR FUTURE REFERENCE.  
HS7900  
 
Features of your Straightener.  
On/Off Switch  
Power  
On  
Light  
Variable  
temperature  
selector  
Scissor action handle  
Smooth  
straightening  
plates  
PTC Elements  
Automatic Voltage Adjustment  
The professional-style PTC elements ensure that  
your straightener heats up quickly, and  
maintains constant temperature during styling  
for best results.  
The voltage automatically adjusts between 110  
and 240 volts depending on the local power  
supply, making it ideal for traveling.  
Scissor-Action Handle  
Variable Temperature Control  
Provides greater control during straightening.  
The handle automatically releases, and squeezes  
closed to provide smooth, even straightening.  
Allows you to adjust the temperature of the  
straightening plates, depending on the type of  
hair to be straightened. Use lower heat on fine  
hair, or to smooth almost straight hair. Use  
higher heat to straighten stubborn, resistant  
curls.  
Non-stick Plates  
The straightening plates are non-stick for  
smooth, easy styling.  
 
Using your Straightener.  
1. Insert the plug into the power outlet and  
turn the power on.  
6. For best results, start at the scalp and work to  
the ends of the hair. Place the separated  
section of hair between the flat plates and  
close the handle gently around the hair.  
2. Move the on/off switch to the on position (I).  
3. Select the desired heat level by rotating the  
temperature dial on the side of the styler. Use  
lower heat for fine hair, or for smoothing  
almost-straight hair. Use higher heat for  
thicker hair, or more resistant curls.  
7. Hold the styler in position for 3 to 5 seconds,  
depending on the type of hair (3 seconds for  
fine hair and up to 5 seconds for thicker hair).  
8. Once the hair is heated carefully slide the  
styler along the section of separated hair,  
making sure that the hair is heated and  
straightened all the way to the ends.  
4. Allow the straightener to heat for several  
minutes before using.  
5. Brush your hair thoroughly. Separate out a  
section of hair approximately 4cm in width  
and smooth it with a comb.  
9. Select another section of hair and repeat the  
process. Continue until all of the hair has  
been straightened.  
Care and Cleaning.  
After use, remove the plug from the power  
outlet and allow the styler to cool before storing.  
To clean the plates, wipe with a soft cloth  
moistened with a solution consisting of a small  
amount of hair shampoo in warm water. Wipe  
the outside of the styler with a damp cloth, and  
dry with a soft cloth.  
Do not wrap the cord around the styler when  
not in use. Store in a dry place.  
Sunbeam is a registered trademark. Made in China. Due to  
minor changes in design or otherwise, the product may  
differ from the one shown in this leaflet. Approved by the  
appropriate Electrical Regulatory Authorities. Backed by  
Sunbeam‘s 2 Year Replacement Guarantee and National  
Service Network.  
© Copyright. SUNBEAM CORPORATION LIMITED 2002.  
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771  
For more information or advice on this or any other  
Sunbeam appliance, visit www.sunbeam.com.au  
or contact the Sunbeam Consumer Service Line.  
Australia 1800 025 059  
New Zealand (09) 912 0747.  
 

Sennheiser Water System SDC 8200 SYS M User Manual
Sharp Car Video System PN V602 User Manual
Sharp Flat Panel Television LC 45GD4U User Manual
Sharp Microwave Oven R 1520L User Manual
Sony Flat Panel Television SL Series User Manual
Sony Headphones NWZ E443 User Manual
Sony MP3 Player ZS M7 User Manual
Sony Music Mixer DMBK R101 User Manual
Speco Technologies DVR EZVR4 User Manual
Sunbeam Styling Iron HS9500 User Manual